| Input Connectors | 1/4'' TRS, female XLR (pin 2 hot) |
| Input Type | Electronically balanced/ unbalanced, RF filtered |
| Input Impedance | Balanced 40k Ohm, unbalanced 20k Ohm |
| Max input | > + 21dBu balanced or unbalanced |
| CMRR | >40dB, typically >55dB at 1kHz |
| Output Connectors | 1/4'' TRS, male XLR (pin 2 hot) and barrier terminal strip |
| Output Type | Impedance-balanced/ unbalanced, RF filtered |
| Output Impedance | Balanced 200 Ohm, unbalanced 100 Ohm |
| Max Output | >+21dBu balanced/ unbalanced into 2k Ohm or greater; >+18dBm balanced/unbalanced(into 600Ohm) |
| Bandwith | 20Hz to 20kHz, +0.5/-1dB |
| Frequancy Response | < 10Hz to > 50kHz, +0.5/-3dB |
| Signal to Noise (NR In: +/-6 and 15dB ranges) | >102dB unweighted, ref: +4dBu, 22kHz measurement bandwidth |
| Dynamic Range (NR In: +/-6dB and +/-15dB ranges) | >120, unweighted |
| Signal to Noise (NR Out: +/-6dB range) | >94dB unweighted, ref: +4dBu, 22 kHz measurment bandwith |
| Dynamic Range (NR Out: +/-6dB range) | >112dB, unweighted |
| Signal to Noise (NR Out: +/-6dB range) | >90dB unweighted, ref: +4dBu, 22 kHz measurment bandwith |
| Dynamic Range (NR Out: +/-6dB range) | >108dB, unweighted |
| THD + Noise | <0.04%, 0.02% typical at + 4dBu,1kHz |
| NR Switch | Activates dbx Type III Noise Reduction |
| Bypass Switch | Bypasses the graphic equalizer section in the signal path |
| Low cut switch | Activates the 40Hz 18dB/ Octave high-pass filter |
| Range Switch | Select either +/-6dB or +/-15dB slider boost/cut range |
| I/O Meter | 4-LED bar graph(Green, Green, Yellow, Red) at -10,0,+10 and +18 dBu |
| Indicators | NR Active (Yellow)EQ Bypass(Red); Clip (Red); Low Cut(Red); +/-6dB(Yellow); +/-15dB(Red) |
| Operating Voltage | 100VAC 50/60Hz; 120VAC 60Hz; 230VAC 50/60Hz |
| Power Consumption | 28W |
| Power Connector | IEC receptacle |
| Unit Weight | 8.5 lbs (3.9kg) |
| Shipping Weight | 9.5 lbs (4.3kg) |
| Dimensions | 3.5'' (8.9cm) H x 7.9''(15.24cm) D x 19'' (48.26cm) W |
